NOTE: V 699 has been factory installed on PDM 1383 Ser# 2489

RELEASE NOTES

V 699 -  [Current Release]
* solved an issue where a power cycle could cause invalid internal dip switch settings when audio expert mode was enabled
* solved an issue where the bi-directional mode did not work properly after a power cycle

---------------------------------
This is a cumulative Upgrade which includes previous releases below:

V672
* solved an issue where 3G-SDI Level B DL input signals were not displayed correctly in yelloGUI
* revised mute functionality for single audio channels in expert mode (audio crossbar in yelloGUI)

V 669
+ added a new feature as a software option which allows to change the audio routing using the yelloGUI 2.1.0 and above (audio crossbar)
* solved an issue where a luma/chroma invertion could occur in some special cases


V 647
+ added support for 3G - SDI Level B Dual Link input signals
* solved an issue where audio channels could be swapped after signal change on the SDI input
* revised signal polarity for D/A converters (analog audio outputs)
* solved an issue where the Auto Black output signal did not work after a module power cycle
* audio outputs will now be muted during a signal change on the SDI input

V 628
+ added embedding, de-embedding and displaying of metadata WSS, VI & AFD (available in yelloGUI 1.3.0 or higher)
+ added yelloGUI support (available in yelloGUI 1.3.0 or higher)


V 590
* revised yellobrik installer (improved LYNX USB driver installation)


V588
+ Revised device audio initialization on powerup, which could lead to swapped audio channels very rarely